各位帮看看遇到一个棘手问题 1301 动态配置频段 发现延迟...
由于客户要求将1301做成了单信道平台下发修改频段指令配置不同频段 平台 配置频段1301参数比较频繁 代码在下面遇到问题是每次重新配置必须要 lgwstop 然后 再lgwstart 但是发现配置完后 这个时间比较长 要3秒左右 由于我集中器配置完就马上抄表了 这个3秒时间太长了平台而且是 每10秒就要配置一次频段参数 导致时间大大拉长而且我发现 调用 lgwsop lgwstart 这组函数频繁的话 会出现如下错误 我的整体配置代码在最下面 有遇到过解决了这个问题的请指教lgw_start:999: ERROR: Version of AGC firmware not expected, actual:2 expected:4
2019-04-28 13:53:23.564 lgw_pkt_entry.c: ERROR: failed to start the concentrator
void lgwparaConfigure(uint32_t freq) {
int ret = -1;
static uint32_t Prefreq = 0;
struct lgw_conf_rxif_s ifconf;
struct lgw_conf_rxrf_s rfconf;
ret = lgw_stop();
if(ret != LGW_HAL_SUCCESS) {
goto ERRON_EXIT;
}
if(!access(global_cfg_path, R_OK)) {
CULog("INFO:found global configuration file %s and parse it", global_cfg_path);
int ret = pare_sx1301_configuration(global_cfg_path);
if(ret != 0) {
goto ERRON_EXIT;
}
}
memset(&rfconf, 0, sizeof(rfconf));
memset(&ifconf, 0, sizeof(ifconf));
rfconf.enable = true;
rfconf.freq_hz = freq;
rfconf.rssi_offset = -166.0;
rfconf.type = LGW_RADIO_TYPE_SX1255;
rfconf.tx_enable = true;
rfconf.tx_notch_freq = DEFAULT_NOTCH_FREQ;
lgw_rxrf_setconf(0, rfconf); /* radio A, f0 */
ifconf.enable = true;
ifconf.rf_chain = 0;
ifconf.freq_hz = 0;
ifconf.datarate = DR_LORA_SF8;
lgw_rxif_setconf(0, ifconf);
ret = lgw_start();
if(ret == LGW_HAL_SUCCESS) {
CULog("INFO: concentrator started, packet can now be received\n");
}
else {
CULog("ERROR: failed to start the concentrator\n");
goto ERRON_EXIT;
}
pthread_mutex_lock(&pthread_mutex_recvlock);
lgw_recvflag = true;
pthread_mutex_unlock(&pthread_mutex_recvlock);
return;
ERRON_EXIT:
if(raise(SIGINT) == -1) {
CULog("WARNING:singnal raise fail.");
exit(EXIT_FAILURE);
}
}
页:
[1]